This allows a proportion of the signal that has been removed by clipping to be added back to the output. At settings below 1.0, the volume of the result will be reduced. If left at default level of 1.0, all sounds below the dB limit are fed to the output. It thus acts as a volume control for audio below the dB limit. The amount of the clipped signal that is fed to the output. If the Wet level and Residue level settings are left at default, the peak level of the result will be clipped down to this level. The level above which the input signal is processed.

To reduce her any more, you'd probably need to split to two mono tracks and try further limiting on the left channel, as that appears where she's hanging out most of the time. I leave this at -0.2 dB though if you're going to do additional effects or processing some would prefer lower.īanshee lady should now be about equal in level to the highest peaks in the music. First two boxes are checked third is not. Again make sure everything is selected, then go to Effect > Normalize.

See the quote from the manual below for more info.)Ĥ. Residue level controls how 'hard' (low number) or 'soft' (high number) the limiter is. (Note - the dB limit takes a bit of trial and error to make sure your limiting what you want but not harming the music. Set your dB limit to -24, Wet level 1.0, Residue level 0.2. Select the whole thing, and open the Hard Limiter module.Ģ. I played around with your file a bit more.

Hard limiter audacity plugin